LG C Series - Manual (Page 66)

Chapter 9. Basic functions
9.3
Run Command setting
z Run via the Run and STOP/RST key
Group LED Display Parameter Name
Set
Value
Min/Max
Range
Factory
Defaults
Unit
drv
[Drive mode]
(Run/Stop mode)
0 0/3 1
Drive
group
drC
[Direction of motor
rotation select]
- F/r F
ƒ Set drv – [Drive mode] to 0.
ƒ Motor starts to accelerate by pressing the Run key while run frequency is set. Motor decelerates to
stop by pressing the STOP/RST key.
ƒ Selecting rotation direction is available at drC - [Direction of motor rotation select] when run
command is issued via Run key on keypad.
FX : Counter clockwise
F Forward
drC [Direction of motor
rotation select]
R Reverse
z Run command setting 1 via FX and RX terminals
Group LED Display Parameter Name
Set
Value
Min/Max
Range
Factory
Defaults
Unit
Drive
group
drv
[Drive mode]
(Run/Stop mode)
1 0/3 1
I20
[Multi-function input
terminal P1 define]
0 0/24 0
I/O
group
I21
[Multi-function input
terminal P2 define]
1 0/24 1
ƒ Set drv – [Drive mode] to 1.
ƒ Set I20 and I21 to 0 and 1 to use P1 and P2 as FX and RX terminals.
ƒ “FX” is Forward run command and “RX” Reverse run.

Operation will stop when both FX and RX terminals are turned ON or OFF.
FX
RX
Frequency
66