LogTag Recorders LogTag Analyzer Temperature Recorder - Manual (Page 25)

Chapter 3 Quick Start Guide 25
Alert condition
present
Single flash of red LED
every 4 seconds
 displayed when the LogTag has detected an alert
condition (see "Alert Processing" on page 34) and
the Alert LED has been activated
If an alert is present you cannot determine if the
unit is still logging or has finished its log cycle. It
is more important to ensure an alarm condition is
not overlooked, and 8 seconds are to long a time
to still achieve that.
If the Alert LED has not been activated during
configuration, in essence the visual indicators
have been disabled, and the green LED will flash
every 4 or 8 seconds as above.
Communication The green LED will
flash occasionally
 during communication with the interface the
green LED will flash occasionally; no information
is conveyed in this.
Start button
press
red LED glows faintly  This is by design but conveys no information.
Retrieve information from
LogTag
When you are ready to view the recordings that are stored within the LogTag, just place
the LogTag into the Interface Cradle as before. If the LogTag is still recording when you
go to retrieve the readings it will continue to record without interruption so you will be
able to download again later if you choose.
If the LogTag has readings stored within its memory, the software will automatically start
to retrieve a copy of the recording contained within the LogTag and will also display an
animated picture during the download process, similar to the following picture.
Once the readings have been successfully retrieved from the LogTag(s), the software will
display the information for you. The chapter "
Results from LogTag (on page 47)" explains
in more detail the information that is displayed to you as a result of retrieving the
recorded readings from LogTag(s).