Liebert UPS System - Manual (Page 61)

Chapter 5 Operation of Display Panel
55
5.3.2 Address setup
According to the information displayed on Fig.5-22, select the “Equipment Address
Setup” and pressing F3(UP) or F2(DOWN) to modify the address of the equipment,
and then pressing F4 to confirm and exit. If you do not want to modify the language,
pressing F1(ESC) to escape.
2001-11-08 UL33-0400L 12:50:30
Inv. On Units 2/4 ID: 1
Input Breaker Closed 11£ -08 12:09
UPS in Battery Mode
Battery low
11£ -08 12:09
11£ -08 12:28
11£ -08 12:28
11£ -08 12:50
Records
Out
System
Local
Settings
Byp. Breaker Closed
Mains Volt. Abnormal
Battery
Chinese
Chinese English
Com. Adress Set 1
1
Date & Time Set
2001£ -11£ -08 12:50:30
Language
ok
c
Fig. 5-22 Equipment address
5.3.3 Time setup
According to the information displayed on the Fig.5-23, select the “Time Setup” to
modify the system time. If you do not want to modify the language, pressing
F1(ESC) to escape.
2001-11-08 UL33-0400L 12:50:30
Inv. On Units 2/4 ID: 1
Input Breaker Closed 11£ -08 12:09
UPS in Battery Mode
Battery low
11£ -08 12:09
11£ -08 12:28
11£ -08 12:28
11£ -08 12:50
Records
Out
System
Local
Settings
Byp. Breaker Closed
Mains Volt. Abnormal
Battery
Chinese
Chinese English
Com. Adress Set 1
1
Date & Time Set
2001£ -11£ -08 12:50:30
Language
c
ok
Fig. 5-23 Setup the date
Suppose the time is 2001-11-09 12:50:20, pressing F2 (move left) and F3 (move
right) keys to move the cursor to the location of date, as shown in Fig. 5-24.