Liebert 30-130kVA - Manual (Page 61)

Operation
53
Figure 73 Customer alarm interface screen
If there is no board, the “NOT INSTALLED” message is displayed.
3. Pressing NEXT will bring up the second page.
Figure 74 Customer alarm interface screen, page 2
To access the Programmable Relay Board #1, highlight RELAY BOARD #1 from the first page of the
CUSTOMER ALARM INTERFACE screen and press SELECT to bring up the following screen.
Figure 75 Programmable output relay board #1, AS400 assignment
The AS400 pre-assigned relays are shown in this screen.
CUSTOMER ALARM INTERFACE
CANCEL
RELAY BOARD # 1 AS400
RELAY BOARD # 2 NOT INSTALLED
CONTACT BOARD
SAVE & EXIT NEXT
CUSTOMER ALARM INTERFACE
CANCEL
REMOTE LED BOARD # 1.....................................
REMOTE LED BOARD # 2.....................................
REMOTE LED BOARD # 3
SAVE & EXIT PREV
PROGRAMMABLE OUTPUT RELAY BOARD # 1
SAVE & EXIT
PROGRAMMABLE RELAY # 1
PROGRAMMABLE RELAY # 2
PROGRAMMABLE RELAY # 3
BATTERY DISCHARGING
LOW BATTERY WARNING
LOAD ON UPS / LOAD ON BYPASS
CANCEL
RELAY ASSIGNMENTS...........................AS400