Philips T-SMART DBS-EX23-530 - Manual (Page 102)

Appendix A. CPC-EX 2.3 Feature Update Section 530-ISDN Ref.
Page A-12 DBS Manual - Revised April 2000 DBS-2.3-400
Notes
• You must enter programming using the private password to view the
private password address. The private password address will not appear
and is not accessible if programming is entered using the system or remote
password.
• If the system or remote password is set to the same value as the private
password, then the private password address will not be accessible. You
must first change the system or remote password to another value and then
log in again using the private password to have access to the private
password address.
• If you are at an attendant key telephone when entering programming, you
must first enter #98 followed by the 4-digit private password before
entering programming (see below). Otherwise, the private password is not
accessible.
Operation
To access the system using the private password at any display key telephone
(including an attendant telephone):
1. Go off-hook or press ON/OFF key.
2. Dial #98 followed by the 4-digit private password.
3. Press PROG followed by ##.
4. To exit system programming, hang up or press the ON/OFF key.
Terminal Programming Through a Direct Connection
When programming from a terminal connected to the RS-232C (SMDR) port,
perform the following steps:
1. Make certain the cables are configured and connected as outlined in
Section 300.
2. Make certain the DBS is in the SMDR mode by entering the following
code from the attendant port:
ON/OFF #93
3. Enter your terminal communications program and make sure your PC's
data communications settings match those of the DBS.
4. From your terminal communications program, type the following
command: