Philips T-SMART DBS-EX23-530 - Manual (Page 46)

Programming Initial ISDN Options Quick-Start Programming
3-4 DBS-EX22-530 Issued 10/23/98
Programming Initial ISDN Options
The following instructions explain the minimum programming required to
make the ISDN operational, plus the programming required for DID. Each
instruction includes a page number that references the relevant detailed
descriptions in Chapter 4. Default settings appear in bold.
Minimum Programming
Note:Option settings are in parenthesis ( ).
1. Set the system for ISDN operation.
2. If you are installing the ISDN while upgrading to a new DBS release,
perform the “ISDN Data Reset” command (page 4-28).
Note: DID settings are not maintained after the reset function.
3. Enter the system configuration (page 4-3).
Address FF1 2# 1# 44# (1)#
Options 0= T1 Operation
1=ISDN Operation
Address FF1 9# 1# (1)#
Options 0=No (retain settings)
1=Yes (clear settings)
Address FF1 9# 4# 1# 1# (0-8)#
Options 0=DBS 40
1=DBS 72
2=DBS 96
3=DBS 40 + DBS 40 (ISDN must be in the slave cabinet.)
4=DBS 72 + DBS 40 (ISDN is not supported.)
5=DBS 72 + DBS 72 (ISDN must be in the slave cabinet.)
6=DBS 96 + DBS 40
7=DBS 96 + DBS 72
8=DBS 96 + DBS 96