Philips T-SMART DBS-EX23-530 - Manual (Page 49)

Quick-Start Programming Programming Initial ISDN Options
Revised April 2000 DBS-EX23-530 3-7
Slave Cabinet Set-Up
Note:Refer to “Typical Central Office Configurations” on page 3-10 for
setting below options. Default setting are In BOLD
Special Installation for adding second cabinet. If you are adding a second
cabinet (slave) to an existing installation that has a Primary Rate span
configured, you must re-enter the configuration settings for the ISDN
channels in the Master cabinet. The re-dimensioning of the system to the new
double cabinet (master/slave) configuration causes the address of FF1 9# 4#
4# 1# 2# (0-23) to be reset to the default value of zero (0).
9. Set up slave span:
Address FF1 9# 4# 4# 5# 5# (0-1)# ISDN International Dial Code
Deduction
Options 0-Send as is
1-Deduct 011 from the code
Address FF1 9# 4# 4# 5# 6# (0-1)# ISDN Long Distance
Code“1”Deduction
Options 0-Send as is
1-Deduct “1” from the code
Address FF1 9# 4# 4# 5# 7# (0-1)# ISDN Type and Plan Option
Options 0-Determine Type and Plan
1-Always Type and Plan set to Unknown/Unknown
Address FF1 9# 4# 5# 5# 1# (0-1)# Network Type
Options 0-Public
1-Private
Address FF1 9# 4# 5# 5# 2# (0-1)# Auto Progress
Options 0-Disable
1-Enable