Philips T-SMART DBS-EX23-530 - Manual (Page 104)

Appendix A. CPC-EX 2.3 Feature Update Section 530-ISDN Ref.
Page A-14 DBS Manual - Revised April 2000 DBS-2.3-400
Terminal Programming Through Additional RAI Access Method
(See “Additional RAI Access Method”.)
Terminal Programming Commands
Use the following commands to navigate terminal programming:
*Additional RAI Access Method
Description
In addition to the existing RAI access method, a new RAI access method has
been added. A new access code, #97****, has been added to the DBS. When
this code is dialed, a held call is transferred to the RAI modem. The system
then sends a <PASSWORD> prompt and the remote or private password
must be entered to connect to terminal programming. This allows more
security for passwords since the password does not have to be used by the
transferring person or device.
Command Description
~01 Access System parameters
~02 Access Trunk parameters
~03 Access Extension parameters
~04 Access Ring assignments
~05 Access FF-key assignments
~06 Access Name assignments
~07 Access Toll Restriction data
~08 Access Least Cost Routing data
~09 Access Copy mode
~10 Access Speed Dial data
~B Back to previous address
~b Back to previous port
~F Forward to next address
~f Forward to next port
~R Return to provide mode
~Ctrl-Z Quit