Figure 2-3. wiring power to the cvs-1450 device, Connecting to a separate main supply, Connecting to a separate main supply -10 – National Instruments NI CVS-1450 Series User Manual
Page 24: Re 2-3
Advertising
Chapter 2
Setup and Configuration
NI CVS-1450 Series User Manual
2-10
ni.com
camera are not displayed on the monitor, refer to Appendix A,
Figure 2-3. Wiring Power to the CVS-1450 Device
Connecting to a Separate Main Supply
If you use a power supply other than the NI desktop power supply, follow
the instructions in this section to connect power to the CVS-1450 device.
Note
If you are not using the NI desktop power supply, use 0.75 mm
2
, 18 AWG ferrules
according to manufacturer specifications to terminate the wires leading to the 4-position
power connector, shown in Figure 2-4. Ferrules are available from Phoenix Contact
(part number 3200519).
1
4-Position Power Connector
2
NI Desktop Power Supply
3
Power Supply Cord (to Outlet)
1
3
To Outlet
2
Advertising