National Instruments NI CVS-1450 Series - Manual (Page 35)

Chapter 3 LEDs, DIP Switches, and Connectors
© National Instruments Corporation 3-3 NI CVS-1450 Series User Manual
Figure 3-2. ACT/LINK and 100 Mbps LEDs
DIP Switches
This section describes the SAFE MODE, IP RESET, NO APP, and
USER 1 DIP switches on the CVS-1450 device.
To enable a DIP switch, move it to the ON (left) position and then reset the
CVS-1450 device by pressing the RESET button for at least two seconds.
Note You must reset the CVS-1450 device in order for the setting change to occur.
NI 1454
Compact Vision System