National Instruments SCB-68 - Manual (Page 12)

Chapter 1 Introduction
SCB-68 Shielded Connector Block User Manual 1-2 ni.com
❑
The following items, if you are adding components (optional):
– Soldering iron and solder
– Resistors
– Capacitors
Quick Reference Label
A quick reference label for E Series devices is included in this kit. Quick
reference labels for some other devices ship with the DAQ device itself.
These labels show the switch configurations and define the screw terminal
pinouts for compatible DAQ devices. You can put the label on the inside of
the SCB-68 cover for easy reference if you are using one of these devices.
Refer to Appendix B, Quick Reference Labels , for the switch
configurations and screw terminal pinouts that are included on each quick
reference label.
Table 1-1 shows cabling options and features for DAQ devices that are
compatible with the SCB-68. Figure 1-1 shows where to apply the quick
reference label to the inside cover of the SCB-68.
Table 1-1. Device-Specific Hardware Configuration
Device Cable Assembly Features
E Series Devices
68-Pin Devices (except DAQCards) SH68-68-EP,
SH68-68-R1-EP,
R6868 Direct feedthrough only
Thermocouple measurements
Open thermocouple detection
Current input
Filtering
Voltage dividers
AC coupling
100-Pin Devices SH1006868 Direct feedthrough only
Thermocouple measurements
Open thermocouple detection
Current input
Filtering
Voltage dividers
AC coupling