National Instruments SCB-68 - Manual (Page 15)

Chapter 1 Introduction
© National Instruments Corporation 1-5 SCB-68 Shielded Connector Block User Manual
Figure 1-1. SCB-68 Parts Locator Diagram
Installing Cables
The following sections describe how to cable one or more SCB-68
connector blocks to a DAQ device using 68-pin or 100-pin cables.
Note For the I/O connector pinout of the DAQ device, refer to the device user manual at
ni.com/manuals or to the quick reference label provided with the DAQ device.
Using 68-Pin Cables
Table 1-1 lists the 68-pin cable assemblies that can connect the SCB-68 to
a 68-pin DAQ device. Each end of these 68-pin cables has a 68-pin I/O
connector that you can connect to the SCB-68 and to the 68-pin DAQ
device. In this configuration, the I/O connector pinout on the DAQ device
determines the I/O connector pinout on the SCB-68.
1 Quick Reference Label
2 Cover
3 68-Pin Connector
Screws
4 Lock Washers
5 Shielding Screws
6 68-Pin I/O Connector
7 Base
8 Strain-Relief Bars
9 Strain-Relief Screws
10 Circuit Card Assembly
2
3
4
5
7
9
8
1
10
6