National Instruments SCB-68 User Manual
Page 17
Chapter 1
Introduction
© National Instruments Corporation
1-7
SCB-68 Shielded Connector Block User Manual
Figure 1-3. Connecting a 100-Pin DAQ Device to Two SCB-68 Connector Blocks
When you attach two SCB-68 devices to the SH1006868 cable, one of the
SCB-68 connector blocks has a full 68-pin I/O connector pinout, and the
other SCB-68 connector block has an extended AI or extended digital
pinout. Each 68-pin end of the SH1006868 cable has a label that indicates
which I/O connector pinout is associated with that 68-pin I/O connector.
Figure 1-4 shows the pin assignments for the I/O connector on a 68-pin
E Series device. This connector is available when you use the SH68-68-EP
or R6868 cable assemblies with an E Series DAQ device. It is also one of
two 68-pin connectors available when you use the SH1006868 cable
assembly with a 100-pin E Series DAQ device.
1
SCB-68 Connector Blocks
2
68-Pin I/O Connectors
3
SH1006868 Cable Assembly
4
100-Pin DAQ Device
5
100-Pin I/O Connector
4
5
1
2
3