Northern UTA220/UTA220k - Manual (Page 138)

C-4
UTA220/UTA220k
AT Command Set
S4= Line Feed Character Range: 0-127 default (10)
S5= Back Space Character Range: 0-32, 127 default (8)
Range: 33-126, 128-255Disabled
S7= Wait for Connection Range: 0-255 default (30)
Units = Seconds
S10= DCD Drop Time Range: 0-255 default (0)
Units = 1/10 seconds
S12= Guard Time Range: 0-255 default (50)
Units = 1/50 seconds
S25= DTR Detect Time Range: 0-255 default (5)
Units = 1/100 seconds
S26= RTS to CTS Time Range: 0-255 default (1)
Units = 1/100 seconds
&Cn Data Carrier Detect n = 0 Always On < default>
1 Tracks Connection
(async only)
2 Always except during
S10 disconnect
(async only)
&Dn Data Terminal Ready
(DTR) n = 0 Ignore DTR
(async/sync)
< default>
1 Recall ACU (async
only)
2 Hangup-auto answer
disabled while DTR
down (async only)
3 Hangup - reload
parameters
(async only)
9 DTR Dial (async only)
&Kn Flow Control (parity
ignored) n = 0 None <default>
3 Bi-directional
RTS/CTS
4 Bi-directional
XON/XOFF
5 Transparent bi-
directional flow
control
(not supported)
Table C-1: UTA 220 AT Command Set (Continued)
Command Description Value
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+