Northern UTA220/UTA220k - Manual (Page 144)

C-10
UTA220/UTA220k
AT Command Set
%B12= Transmit Through Input
Class 0 Use network default
<default>
1
Reserved
2 Reserved
3 75
4 110
5 300
6 600
7 1200
8 2400
9 4800
10 9600
11 19200
12 48000
13 64000
14 Reserved
15 Reserved
%B13= Network User ID Range: 0-16 characters
default (null string)
%B14= RPOA Range: 0-16 characters
default (null string)
%B15= Called Line Address
Modification Code (Caller,
Read Only) 0 Call not redirected <default>
1 Called station was busy
7 Call distribution within a hunt
group
9 Called station was out of or-
der
15
Systematic call redirection by
called station
Not saved in non-volatile. Initialized
to factory defaults before each virtual
call.
%B16= Called Redirection
Notification Code (Called,
Read Only) 0 Call not redirected <default>
1 Called station was busy
9 Called station was out of or-
der
15
Systematic call redirection by
called station
Not saved in non-volatile. Initialized
to factory defaults before each virtual
call.
%B17= Intended Call Address Range: 0-15 digits default (null
string)
%B18= User Data Range: 0-12 characters
default (null string)
Table C-1: UTA 220 AT Command Set (Continued)
Command Description Value
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+