Northern UTA220/UTA220k - Manual (Page 31)

UTA220/UTA220k
3-7
Getting Started
Setup Step 1
Plug the UTA220 into the power outlet. Turn the power switch
on the rear panel ON.
Note: Do not connect the UTA220 to the ISDN line until the
UTA220 has been properly programmed.
The LCD displays the banner:
ISDN TERMINAL ADAPTER
Setup Step 2
To program the UTA220, perform the steps in Table 3-4. Use
the HOME key any time to back up to correct a mistake.
Table 3-4: Programming Steps
STEP LCD SCREEN
DISPLAY
ACTION
1 ISDN
TERMINAL ADAPTER
Press YES or NO key to advance to the next display.
2 DIAL/HANGUP
OPTIONS? Press NO.
3 STATUS DISPLAYS? Press NO.
4 CONFIGURATION
OPTIONS? Press YES.
5 SWITCH CONFIG
OPTIONS? Press YES.
6 SWITCH TYPE
OPTION? Press YES.
7 NATIONAL ISDN
CHANGE? National ISDN NTI DMS100 AT&T 5ESS
Press NO.
Continue programming
with STEP 9. Press YES until "NTI
DMS100" is displayed,
then press NO. P r e s s Y E S u n t i l
" A T & T 5 E S S " i s
displayed, then press
NO.
8 WILL DESTROY ALL
NET OPTS, CONT? Press YES. The display momentarily shows ’RESETTING SWITCH OPTIONS"
while it changes the switch options to the default values for the selected switch
type.
9 SWITCH TYPE OPTION? Press NO.
10 SWITCH VERSION
OPTION? National ISDN NTI DMS100 AT&T 5ESS
Press No. Continue
programming with STEP
13. Press YES. Press YES.
11 <default version>
VERSION. CHANGE? This screen displays the default version for the switch type you selected above.
Press YES until the correct version is displayed. Press NO to select the switch
version choice. (refer to Chapter 4, ISDN Switches section.)
12 SWITCH VERSION
OPTION? Press NO.
13 D-CHANNEL
OPTIONS? Press YES.