Northern UTA220/UTA220k - Manual (Page 180)

I-2
UTA220/UTA220k
128K Clear Channel Leased-Line Service
Configuring the Port and Protocol
The AT commands in this section let you:
•Configure the port for 128K Clear Channel
•Enter a leased-line dial string in storage area zero
•Save the configuration
•Restart the network so that the leased-line switch
configuration takes effect
This Command... Does This:
AT%A2=0 Sets the port protocol to Clear Channel
AT@B0=2 Sets the rate multiplier to 2
AT&L1 Sets the port for persistent DTR dial
AT&M2 Sets the port for sync mode 2 - DTR dialing
AT&Z=”B1” Sets the stored dial string for leased line operation
AT&W Saves the port-specific configuration
AT>W Saves the switch configuration of SPIDs, DNs,
TEIs, and B-Channel provisioning
AT>Z Restarts the network
Example:
This command string configures the port for 128K Clear Channel, enters a
leased-line dial string, saves the configuration, and restarts the network:
AT%A2=0@B0=2&M2&Z=”B1”&L1&W>W>Z [enter]
Note: enter AT&L1 as one of the last commands to prevent the unit from
attempting to connect immediately. Entering commands as shown in the
example prevents the unit from connecting unexpectedly, before it has
accepted the entire command and saved the configuration.