Northern UTA220/UTA220k - Manual (Page 141)

UTA220/UTA220k
C-7
AT Command Set
@P6= Number of Stop Bits 0 One < default>
1 One and One-Half
2 Two
Port Commands: Action
A Answer
D Dial S = n Dial stored Number n
0-9,#,* Digits
; Return to on-line
command mode
(ATO dial)s
P,T,W
Ignored
H Hangup
In Information n = 0 Product ID ("960")
1 ROM Checksum
2 Checksum
Verification
3 Revision
("4563672-1NRPT3 C34A PASS")
<board#>-<software>
<checksum> <PASS/FAIL>
I4 Numeric Capability String
I8 Verbose Capability String
I9 Plug-and-Play ID
I10 ISDN Link Status
I11 Port Status
I12 User-definable Device ID
On Return On-Line n = 0 Return On-Line
1 Return On-Line
Zn Reload Port from
non-volatile set n n = 0, 1
&Fp Load Port from factory
profile p p = 0, 1
Table C-1: UTA 220 AT Command Set (Continued)
Command Description Value
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+