Netopia 6.3 - Manual (Page 113)

113
Appendix A SHELL Commands
Resets the point-to-point connection over the specified virtual circuit. This com-
mand only applies to virtual circuits that use PPP framing.
Clears the security monitoring log to make room to capture new entries.
This function disconnects the specified WAN User to allow for other users to
access the WAN. This function is only available if the number of WAN Users is
restricted and NAT is on. Use the all parameter to disconnect all users. If you
logon as Admin you can disconnect any or all users. If you logon as User, you can
only disconnect yourself.
Restarts your Cayman Gateway. If you include the optional seconds argument,
your Cayman Gateway will restart when the specified number of seconds have
elapsed. You must enter the complete restart command to initiate a restart.
Displays ATM statistics for 3220-H unit. The optional all argument displays a
more detailed set of ATM statistics.
Displays bridge interfaces maintained by the Cayman Gateway.
Displays the bridging table maintained by the Cayman Gateway.
Displays the most recent crash information, if any, for your Cayman Gateway.
Displays the DHCP relay-agent leases being administered by your Cayman Gate-
way.
Displays the DHCP address information being used by your Cayman Gateway for
each WAN interface.
Displays the DHCP leases stored in RAM by your Cayman Gateway. You can
include the used argument to see the list of DHCP leases that are in use or that
have been used since your Cayman Gateway was restarted. You can include the
free
argument to see the list of DHCP leases that are available for use.
DSL reset ppp vccn
BOTH reset security-log
BOTH reset wan-users [all | ip-address ]
BOTH restart [ seconds ]
DSL show atm [all]
BOTH show bridge interfaces
BOTH show bridge table
BOTH show crash
BOTH show dhcp agent
BOTH show dhcp client
BOTH show dhcp server leases [ used | free ]