Configuring basic ppp settings, Configuring basic ppp settings – Netopia 6.3 User Manual

Page 137

Advertising
background image

137

Appendix A

CONFIG Commands

Configuring Basic PPP Settings

Enables or disables PPP on the Cayman Gateway.

Specifies the Maximum Receive Unit (MRU) for the PPP interface. The integer
argument can be any number between 128 and 2048.

Enables or disables LCP magic number negotiation.

Specifies whether you want the Cayman Gateway to compress the PPP Protocol
field when it transmits datagrams over the PPP link.

Specifies whether you want your Cayman Gateway to send LCP echo requests.
You should turn off LCP echoing if you do not want the Cayman Gateway to drop
a PPP link to a nonresponsive peer.

.

Specifies the maximum number of Configure-NAK messages the PPP module can
send without having sent a Configure-ACK message. The integer argument can
be any number between 1 and 20.

Specifies the maximum number of unacknowledged configuration requests that
your Cayman Gateway will send. The integer argument can be any number
between 1 and 10.

Specifies the maximum number of unacknowledged termination requests that
your Cayman Gateway will send before terminating the PPP link. The integer
argument can be any number between 1 and 10.

Many of these setting commands are designated as

BOTH.

Note however:

For the 3220-H (DSL platform) you must identify the virtual PPP
interface [vccn], a number from 1 to 8.
This argument does not apply to the 2E-H platform.

BOTH

set PPP module [vccn] option { on | off }

BOTH

set PPP module [vccn] mru

integer

BOTH

set PPP module [vccn] magic-number { on | off }

BOTH

set PPP module [vccn] protocol-compression { on | off }

BOTH

set PPP module [vccn] lcp-echo-requests { on | off }

BOTH

set PPP module [vccn] failures-max

integer

BOTH

set PPP module [vccn] configure-max

integer

BOTH

set PPP module [vccn] terminate-max

integer

Advertising