Netopia 6.3 - Manual (Page 147)

147
Appendix A CONFIG Commands
Traffic Shaping Settings
Traffic shaping lets you control how much traffic can flow through an Ethernet
interface by limiting the size of the WAN “pipe.” This function is most suitable for
Internet Service Providers or multi-interface routers.
When you use the traffic-shaping option to set the maximum speed for a router
port, the router will silently discard any packets that exceed the maximum port
speed.
Enables or disables traffic-shaping in the Cayman Gateway.
Enables or disables traffic-shaping on the designated Ethernet interface.
Specifies the maximum number of bits that can be transmitted.
ENET set trafficshape option { on | off }
ENET set trafficshape ethernet option { on | off }
ENET set trafficshape ethernet rate [ 56000 - 10000000 ]