Task 4: make the ipsec tunnel entries – Netopia 6.3 User Manual
Page 78
Advertising
78
Section 4
Configure
Leave the
Enable NAT over Tunnel
choice as
Off
unless your network
administrator instructs otherwise.
Task 4: Make the IPSec Tunnel Entries
Enter the initial group of tunnel parameters. Refer to your Setup Work-
sheet
and the Glossary of VPN Terms as required. Perform the following
steps:
Step 1
Enter tunnel
Name
.
Step 2
Enter the
Peer External IP Address
.
Step 3
Select
Encryption Protocol
from the pulldown menu.
Step 4
Select
Authentication Protocol
from the pulldown menu.
Step 5
Select
Key Management
from the pulldown menu.
This is the only parameter that does not have to be identical to the peer/
remote VPN device
Advertising