Config commands, Atm settings – Netopia 6.3 User Manual

Page 121

Advertising
background image

121

Appendix A

CONFIG Commands

CONFIG Commands

This section describes the keywords and arguments for the various CONFIG com-
mands.

ATM Settings

You can use the CLI to set up each ATM virtual circuit.

Enables the WAN interface of 3220-H to be configured using the Asynchronous
Transfer Mode (ATM) protocol.

Selects the virtual circuit for which further parameters are set. Up to eight VCCs
are supported; the maximum number is dependent on your Cayman Operating
System tier and the capabilities that your Service Provider offers.

Select the virtual path identifier (vpi) for VCC n.

Your Service Provider will indicate the required vpi number.

Select the virtual channel identifier (vci) for VCC n.

Your Service Provider will indicate the required vci number.

Select the encapsulation mode for VCC n. The options are:

Your Service Provider will indicate the required encapsulation mode.

DSL

set atm option {on | off }

DSL

set atm [vccn] option {on | off }

DSL

set atm [vccn] vpi { 0 ... 255 }

DSL

set atm [vccn] vci { 0 ... 65535 }

DSL

set atm [vccn] encap
{ ppp-vc | ppp-llc | ether-vcmux | ether-llc |
ip-vcmux | ip-llc | ppoe-vcmux | pppoe-llc }

ppp-vc

PPP over ATM, VC-muxed

ppp-llc

PPP over ATM, LLC-SNAP

ether-vcmux

RFC-1483, bridged Ethernet, VC-muxed

ether-llc

RFC-1483, bridged Ethernet, LLC-SNAP

ip-vcmux

RFC-1483, routed IP, VC-muxed

ip-llc

RFC-1483, routed IP, LLC-SNAP

pppoe-vcmux

PPP over Ethernet, VC-muxed

pppoe-llc

PPP over Ethernet, LLC-SNAP

Advertising