Bridging settings – Netopia 6.3 User Manual
Page 122
122
Appendix A
CONFIG Commands
Select the number of PPPoE sessions to be configured for VCC n. Up to eight can
be configured on the first VCC; one on the other VCCs. The total must be less
than or equal to eight.
Select the transmission priority for vcc n. The Gateway transmits traffic for high
priority VCCs before it transmits traffic for low priority VCCs. Bandwidth is split
between VCCs of equal priority.
Specifies the maximum upstream (transmission) rate of the virtual circuit (mea-
sured in kilobytes per second). Zero (0) indicates no restriction on transmission
rate.
Bridging Settings
Bridging lets the Cayman Gateway use MAC (Ethernet hardware) addresses to
forward non-TCP/IP traffic from one network to another. When bridging is
enabled, the Cayman Gateway maintains a table of up to 255 MAC addresses.
Entries that are not used within 10 minutes are dropped. If the bridging table fills
up, the oldest table entries are dropped to make room for new entries.
Virtual circuits that use IP framing cannot be bridged.
Enables or disables bridging services in the Cayman Gateway. You must enable
bridging services within the Cayman Gateway before you can enable bridging for
a specific interface.
Enables or disables bridging services for the Ethernet interface.
Enables or disables bridging services for the specified virtual circuit using Ethernet
framing.
Enables or disables bridging services for the specified Ethernet interface.
Enables or disables bridging services for the specified Ethernet interface.
Enables or disables bridging between virtual circuit connections.
DSL
set atm [vccn] pppoe-sessions { 1 ... 8 }
DSL
set atm [vccn] tx-priority [ low | high ]
DSL
set atm [vccn] tx-max-kbps [ 0 <no limit> | 1 -1000 ]
BOTH
set bridge option {on | off }
ENET
set bridge ethernet [A | B] option { on | off }
DSL
set bridge ethernet option { on | off }
ENET
set bridge ethernet [A | B] filters pppoe-only { on | off }
DSL
set bridge ethernet A filters pppoe-only { on | off }
DSL
set bridge interwan-bridging { on | off }