Netopia 6.3 - Manual (Page 129)

129
Appendix A CONFIG Commands
Specifies whether the Gateway is reached using a fixed IP address or through a
PPP virtual circuit.
Specifies the IP address of the default IP Gateway.
WAN-to-WAN Routing Settings
Use the following command to configure settings for routing between WAN con-
nections.
Enables or disables routing between WAN connections.
IP-over-PPP Settings
Use the following commands to configure settings for routing IP over a virtual PPP
interface.
Enables or disables IP routing through the virtual PPP interface. By default, IP rout-
ing is turned off. You must enable IP routing before you can enter other IP routing
settings for the virtual PPP interface. If you turn off IP routing and save the new
configuration, the Cayman Gateway clears IP routing settings
.
Assigns an IP address to the virtual PPP interface. If you specify an IP address other
than 0.0.0.0, your Cayman Gateway will not negotiate its IP address with the
remote peer. If the remote peer does not accept the IP address specified in the
ip_address
argument as valid, the link will not come up.
DSL set ip gateway interface { ip-address | ppp-vccn}
BOTH set ip gateway default ip_address
BOTH set ip interwan-routing { on | off }
Many of these setting commands are designated as BOTH.
Note however:
For the 3220-H (DSL platform) you must identify the virtual PPP
interface [vccn], a number from 1 to 8.
This argument does not apply to the 2E-H platform.
BOTH set ip ip-ppp [ vccn ] option { on | off }
BOTH set ip ip-ppp [ vccn ] address ip_address