Netopia 6.3 - Manual (Page 136)

136
Appendix A CONFIG Commands
Specifies the type of protocol being redirected.
If you select other, specifies the number of the protocol you want to translate.
Specifies the first port number in the range being translated.
Specifies the last port number in the range being translated.
.
Specifies the IP address of the internal host to which traffic of the specified type
should be transferred.
Specifies the port number your Cayman Gateway should use when forwarding
traffic of the specified type. Under most circumstances, you would use the same
number for the external and internal port.
PPPoE Settings
You can use the following commands to configure basic settings, port authentica-
tion settings, and peer authentication settings for PPP interfaces on your Cayman
Gateway.
Enables or disables PPP over Ethernet on your 2E-H unit. You must enable PPPoE
before you can enter other PPP settings.
BOTH set pinhole protocol-select
{ tcp | udp | icmp | pptp | other }
BOTH set pinhole numerical-protocol [ 0 - 65535 ]
BOTH set pinhole external-port-start [ 0 - 65535 ]
BOTH set pinhole external-port-end [ 0 - 65535 ]
BOTH set pinhole internal-ip internal-ip
BOTH set pinhole internal-port internal-port
ENET set pppoe { on | off }