NetComm NP2624M - Manual (Page 64)

64 NP2624M User Guide
YML827 Rev1
4.2.1. Port Configuration
This page allows you to change the status of every port.
Press the Space key to change the configuration of each item.
InRate (100K/unit): User can set input rate control, which is 100K per
unit. The valid range is 0~1000.
0: disable rate control.
1~1000: valid rate value.
OutRate (100K/unit): User can set output rate control, which is 100K per
unit. The valid range is 0~1000.
0: disable rate control.
1~1000: valid rate value.
Enabled: User can disable or enable this port control.
“Yes” that mean the port is enabled.
“No” that mean the port is disabled.
Auto: User can set auto negotiation mode to “Auto”,
“Nway_Force”, or “Force” per port.
Spd/Dpx: User can set “100Mbps” or “10Mbps” speed on port
1~port 24.
Set “1000Mbps”, “100Mbps” or “10Mbps” speed
on port25~port26 (dependant on optional Gigabit
module card), and set “full-duplex” or “half-duplex”
mode.
Flow Control: Full: User can enable or disable full flow control
function (pause).
Half: User can enable or disable half flow control
function (backpressure).