Unipolar input selection, Figure 2-13. unipolar input jumper configuration, Figure 2-12 – National Instruments Low-Cost Multifunction I/O Board for ISA Lab-PC+ User Manual
Page 30: Figure 2-13, Unipolar input jumper configuration
Advertising
Configuration and Installation
Chapter 2
Lab-PC+ User Manual
2-14
© National Instruments Corporation
•
•
•
A
B
C
W3
B
U
Figure 2-12. Bipolar Input Jumper Configuration (Factory Setting)
Unipolar Input Selection
You can select the unipolar (0 to 10 V) input configuration by setting the following jumper:
Analog Input
W3
B-C
This configuration is shown in Figure 2-13.
•
•
•
A
B
C
W3
B
U
Figure 2-13. Unipolar Input Jumper Configuration
Note:
If you are using a software package such as NI-DAQ or LabWindows/CVI, you may
need to reconfigure your software to reflect any changes in jumper or switch settings.
Advertising