Nortech Systems Adept RS-232/TERM - Manual (Page 37)

Adept SmartController User’s Guide, Rev. E 37
SmartController Operation
3
3.1 SmartController CS Connectors and Indicators
Figure 3-1. SmartController CS
All the connectors on the SmartController use standard density spacing, D-subminiature
connectors. For customization purposes, the user needs to provide connectors of the
appropriate gender and pin count or use optional Adept cables.
NOTE: The SmartController CX has all of the connectors and indicators
described in this section for the SmartController CS, plus additional ones
covered in
Section 3.2 on page 40 .
1. Top Three Status LEDs
The top three two-color LEDs indicate diagnostic test, power control, and communication
status.
During system bootup, the red OK/SF and HPE/ES LEDs are lit and the red LAN/HD LED
blinks. After system bootup, the OK/SF LED should show green. If the HPE/ES LED shows
red, the E-Stop circuit is open. During CompactFlash reads and writes, the LAN/HD LED
pulses red. When the controller is active on an Ethernet network, the LAN/HD LED pulses
green.
Table 3-1. SmartController LEDs
LED Green Indicates Red Indicates
OK/SF System OK System Fault
HPE/ES High Power Enabled E-Stop Open
LAN/HD Ethernet Access Read/Write from
CompactFlash
1 2 3
RS-422/485
XUSR XSYS
SF
XMCP
1.1
SmartController CS
LAN HPE
OFF
24V 5A
ON
RS-232/TERM
XFP
HD ES
XDIO
Eth 10/100
*S/N 1000-XXXXX*
SW1
Device Net
SmartServo
XDC1 XDC2
- + - +
1 2 3 4
OK
R
1.2