Nortech Systems Adept RS-232/TERM - Manual (Page 71)

Camera Cables
Adept SmartController User’s Guide, Rev. E 71
Four-Camera Breakout Cable for RS-170 Cameras
This cable, available from Adept (P/N 10332-01375) has a 44-pin D-sub connector on one
end, and it breaks out to four 12-pin Hirose-style camera connectors and one 9-pin D-sub
connector on the other end. The length of the cable is 1.8 meters (70 inches).
Dual megapixel camera applications require a four-camera cable since their combined
current draw exceeds the sAVI board's 1A limit in the absence of external power. An
external 12V power supply is required for this application.
Similarly, due to the current limitation of the sAVI board, it cannot supply enough current
to operate all four cameras from the four-camera cable. You must supply the external
power to operate the cameras when using this cable. This power must be routed through
the 9-pin D-sub connector, see
Figure 4-2 and Table 4-2 for pin information. Connect the
power and ground on the breakout cable to a 12V power supply producing 2.0A at
12VDC.
Figure 4-2. Four-Camera Breakout Cable For RS-170 Cameras
10-Meter Camera Extension Cables
The 10-meter camera extension cables have a male Hirose connector on one end and a
female Hirose connector on the other end. These cables go between the breakout cables
and the connectors on the cameras. Each camera requires one of these cables (or an
equivalent). See
Table 4-3 on page 77 for the pinout.
ADEPT CABLE ASSY. CAMERA INTERFACE 4X
CAM 1
CAM 2
1 31
15 44
CAM 3
CAM 4
5 9
1
6
To Camera connector on
SmartController CX
D-sub
Auxiliary
Connector
Pin Signal
1 User +12V to cameras
2 User power return
3 Strobe 1
4 Strobe return
5 Strobe 2
6 Reserved
7 Reserved
8 Reserved
9 Shield (chassis ground)
D-sub Auxiliary Connector
Pin Assignments