Netopia Firmware 4000-Series - Manual (Page 220)

9-10 Firmware User Guide
Simple Network Management Protocol (SNMP) - V2c
The Netopia Firmware Version 5.4 includes a Simple Network Management Protocol (SNMP) agent, allowing
monitoring and configuration by a standard SNMP manager. Netopia Routers and IADs now suppor t both
SNMP-V1 and SNMP-V2c.
Enterprise-specific SNMP Changes
Enterprise-specific SNMP changes in Netopia Firmware Version 5.4 include restar ting the device as a bridge or
router, and controlling the ‘WAN changes reset immediately’ item.
Restart Item: The OID responsible for restar ting the router can now tell it to star tup as a router or a bridge.
Note that if the device was a router and is now told to be a bridge (or vice-versa) the device will be factor y
defaulted.
WAN Changes take effect immediately: This item is found in the console menu and is now added as an SNMP
OID. The router will reboot if the value is changed.
These changes have been added to the SNMP MIB file NETOPIA.MIB.
This MIB is available by anonymous ftp from the Netopia ftp ser ver.
MIBs are available in a variety of formats. Load this MIB into your SNMP management software. Follow the
instructions included with your SNMP manager on how to load MIBs.
The Netopia Firmware Version 5.4 suppor ts the following management information base (MIB) documents:
■ MIB II (RFC 1213)
■ Inter face MIB (RFC 1229)
■ Ethernet MIB (RFC 1643)
■ Netopia MIB
■ SNMP-v2 Traps: SNMP v2 MIB (RFC1907) v2 traps only; npaV2trap.mib (Netopia-specific)
■ ATM: ATM TC (RFC2514); ATM MIB (RFC2515)
■ ADSL: ADSL MIB (RFC2662)
These MIBs are on the Netopia CD included with the Router. Load these MIBs into your SNMP management
software in the order they are listed here. Follow the instructions included with your SNMP manager on how to
load MIBs.
You can also obtain the latest updated SNMP MIBs from the Netopia anonymous FTP ser ver.
FTP to: ftp.netopia.com/pub/router/snmpinfo.