Netopia Firmware 4000-Series - Manual (Page 36)

2-18 Firmware User Guide
Quality of Service (QoS) settings
■ Select the QoS (Quality of Ser vice) setting from the pop-up menu: UBR. or CBR.
UBR: No configuration is needed for UBR VCs. Leave the default value 0 (maximum line rate).
CBR: One parameter is required for CBR VCs. Enter the Peak Cell Rate that applies to the VC. This
value should be between 1 and the line rate. You set this value according to specifications defined by
your ser vice provider.
■ The Peak Cell Rate field is editable. Netopia Firmware Version 5.4 suppor ts two ATM classes of ser-
vice for data connections: Unspecified Bit Rate (UBR) and Constant Bit Rate (CBR). You can configure
these classes of ser vice on a per VC basis. The default ATM class of ser vice is UBR.
■ Then, select a Connection Profile for the Circuit. To use the Default Profile, select Use Default Profile
for Circuit and press Return. For other options, select a profile from the Use Connection Profile
pop-up menu.
Add Circuit
Circuit Name: Circuit 2
Circuit Enabled: Yes
Circuit VPI (0-255): 0
Circuit VCI (32-65535): 32
QoS... CBR
Peak Cell Rate (0 = line rate): 0
Use Connection Profile... Default Profile
Use Default Profile for Circuit
ADD Circuit NOW CANCEL
Return accepts * ESC cancels * Left/Right moves insertion point * Del deletes.