Netopia Firmware 4000-Series - Manual (Page 58)

2-40 Firmware User Guide
Exposed Addresses
You can specify the IP addresses you want to expose by selecting Add Exposed Address List and pressing
Return. The Add Exposed Address List screen appears.
Add, Edit, or delete exposed addresses options are active only if NAT is disabled on an WAN inter face. The
hosts specified in exposed addresses will be allowed to receive inbound traffic even if there is no
corresponding outbound traffic.
Stateful Inspection Parameters
+Exposed Address List N+
+----------------------+
Max. TCP Sequ| my_xposed_list | 0
| <<None>> |
Enable defaul| | No
| |
Deny Fragment| | No
| |
Exposed Addre| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
+----------------------+
Up/Down Arrows to select, then Return/Enter; ESC to cancel.
Add Exposed Address List
Exposed Address List Name: my_xposed_addr_list
Return accepts * ESC cancels * Left/Right moves insertion point * Del deletes.