National Instruments PCI-6023E - Manual (Page 130)

Index
© National Instruments Corporation I-7 PCI-6023E/6024E/6025E User Manual
summary of input connections
(table), 4-12
types of signal sources, 4-8 to 4-9
analog output, 4-20
digital I/O, 4-21 to 4-23
all boards, 4-21 to 4-22
PCI-6025E only, 4-22 to 4-23
power-up state, 4-24 to 4-25
field wiring considerations, 4-49 to 4-50
I/O connectors, 4-1 to 4-8
exceeding maximum ratings
(caution), 4-1
I/O connector signal descriptions
(table), 4-4 to 4-6
I/O signal summary (table),
4-7 to 4-8
pin assignments (figure), 4-2 to 4-3
I/O connectors, optional, B-2 to B-6
50-pin E Series connector pin
assignments (figure), B-5
50-pin extended digital input
connector pin assignments
(figure), B-6
68-pin E Series connector pin
assignments (figure), B-3
68-pin extended digital input
connector pin assignments
(figure), B-4
Port C pin assignments, 4-23
power connections, 4-30
timing connections, 4-30 to 4-49
DAQ timing connections,
4-32 to 4-40
general-purpose timing signal
connections, 4-43 to 4-49
programmable function input
connections, 4-31 to 4-32
waveform generation timing
connections, 4-40 to 4-43
timing specifications, 4-25 to 4-29
mode 1 input timing (figure), 4-27
mode 1 output timing (figure), 4-28
mode 2 bidirectional timing
(figure), 4-29
signal names used in diagrams
(table), 4-25 to 4-26
signal sources, 4-8 to 4-9
floating signal sources, 4-9
ground-referenced signal sources, 4-9
single-ended connections, 4-17 to 4-19
floating signal sources
(RSE configuration), 4-18
grounded signal sources
(NRSE configuration), 4-18 to 4-19
when to use, 4-17
SISOURCE signal, 4-40
software installation, 2-1
software programming choices, 1-3 to 1-5
ComponentWorks, 1-3
LabVIEW and LabWindows/CVI, 1-3
National Instruments application
software, 1-3
NI-DAQ driver software, 1-3 to 1-4
register-level programming, 1-5
VirtualBench, 1-3
specifications
analog input, A-1 to A-4
accuracy information, A-2
amplifier characteristics, A-3
dynamic characteristics, A-4
input characteristics, A-1 to A-2
stability, A-4
transfer characteristics, A-3
analog output, A-4 to A-6
accuracy information, A-5
dynamic characteristics, A-6
output characteristics, A-4 to A-5
stability, A-6
transfer characteristics, A-5
voltage output, A-6
calibration, A-9
digital I/O, A-6 to A-8
DIO<0..7>, A-7
PCI.book Page 7 Wednesday, September 16, 1998 9:09 AM