Port c pin assignments, Table 4-3. port c signal assignments, Port c pin assignments -23 – National Instruments PCI-6023E User Manual
Page 52: Table 4-3, Port c signal assignments -23
Chapter 4
Signal Connections
©
National Instruments Corporation
4-23
PCI-6023E/6024E/6025E User Manual
In Figure 4-11, port A of one PPI is configured for digital output, and
port B is configured for digital input. Digital input applications include
receiving TTL signals and sensing external device states such as the state
of the switch in Figure 4-11. Digital output applications include sending
TTL signals and driving external devices such as the LED shown in
Figure 4-11.
Port C Pin Assignments
♦
PCI-6025 Only
The signals assigned to port C depend on how the 82C55A is configured.
In mode 0, or no handshaking configuration, port C is configured as two
4-bit I/O ports. In modes 1 and 2, or handshaking configuration, port C
is used for status and handshaking signals with any leftover lines available
for general-purpose I/O. Table 4-3 summarizes the port C signal
assignments for each configuration. You can also use ports A and B in
different modes; the table does not show every possible combination.
Note
Table 4-3 shows both the port C signal assignments and the terminology
correlation between different documentation sources. The 82C55A terminology
refers to the different 82C55A configurations as modes, whereas NI-DAQ,
ComponentWorks, LabWindows/CVI, and LabVIEW documentation refers to
them as handshaking and no handshaking.
Table 4-3. Port C Signal Assignments
Configuration Terminology
Signal Assignments
PCI-6023E/
6024E/6025E
User Manual
National
Instruments
Software
PC7
PC6
PC5
PC4
PC3
PC2
PC1
PC0
Mode 0
(Basic I/O)
No
Handshaking
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
Mode 1
(Strobed Input)
Handshaking
I/O
I/O
IBF
A
STB
A
*
INTR
A
STB
B
*
IBFB
B
INTR
B
Mode 1
(Strobed Output)
Handshaking
OBF
A
*
ACK
A
*
I/O
I/O
INTR
A
ACK
B
*
OBF
B
*
INTR
B
Mode 2
(Bidirectional
Bus)
Handshaking
OBF
A
*
ACK
A
*
IBF
A
STB
A
*
INTR
A
I/O
I/O
I/O
*Indicates that the signal is active low.
Subscripts A and B denote port A or port B handshaking signals.
PCI.book Page 23 Wednesday, September 16, 1998 9:09 AM