Generalpurpose timing signal connections, Gpctr0_source signal, Figure 4-34. uisource signal timing – National Instruments PCI-6023E User Manual
Page 72: General-purpose timing signal connections -43, Gpctr0_source signal -43, Figure 4-34, Uisource signal timing -43, Plained in the, General-purpose, Timing signal connections
Chapter 4
Signal Connections
©
National Instruments Corporation
4-43
PCI-6023E/6024E/6025E User Manual
Figure 4-34. UISOURCE Signal Timing
The maximum allowed frequency is 20 MHz, with a minimum pulse width
of 23 ns high or low. There is no minimum frequency limitation.
Either the 20 MHz or 100 kHz internal timebase normally generates the
UISOURCE signal unless you select some external source.
General-Purpose Timing Signal Connections
The general-purpose timing signals are GPCTR0_SOURCE,
GPCTR0_GATE, GPCTR0_OUT, GPCTR0_UP_DOWN,
GPCTR1_SOURCE, GPCTR1_GATE, GPCTR1_OUT,
GPCTR1_UP_DOWN, and FREQ_OUT.
GPCTR0_SOURCE Signal
Any PFI pin can externally input the GPCTR0_SOURCE signal, which is
available as an output on the PFI8/GPCTR0_SOURCE pin.
As an input, the GPCTR0_SOURCE signal is configured in the
edge-detection mode. You can select any PFI pin as the source for
GPCTR0_SOURCE and configure the polarity selection for either rising
or falling edge.
As an output, the GPCTR0_SOURCE signal reflects the actual clock
connected to general-purpose counter 0. This is true even if another PFI
is externally inputting the source clock. This output is set to tri-state at
startup.
Figure 4-35 shows the timing requirements for the GPCTR0_SOURCE
signal.
t
p
t
w
t
w
t
p
t
w
= 50 ns minimum
= 23 ns minimum
PCI.book Page 43 Wednesday, September 16, 1998 9:09 AM