Raritan Engineering Command Center CC-SG - Manual (Page 169)

C HAPTER 11: S YSTEM M AINTENANCE 153
Chapter 11: System Maintenance
Reset CC-SG
Use the Reset CommandCenter command to reset CC-SG database data – please note that this
command will not reset system configuration data, such as the IP address of CC-SG.
1. On the Setup menu, click Reset CommandCenter.
Figure 180 Reset CC-SG Screen
2. Type your CC-SG password.
3. Either accept the current Broadcast message or edit to create one of your own.
4. Type the number of minutes in which to wait until CC-SG is reset in Reset after (min).
Default is 0, which will reset the CC-SG unit immediately.
5. Click OK to reset your CC-SG unit. A success message will appear to confirm the reset.
Important: Using the Reset command will flush the database of CC-SG. All
Devices, Ports, and Users will be removed from the CC-SG. Authentication is
also reset to using Local DB. You should back up the CC-SG before using
Reset.
Backup CC-SG
1. On the Setup menu, click Backup CommandCenter.
2. When the Backup CommandCenter screen appears, if desired, check Do not backup logs if
you do not want the log files backed up. Also check Do not backup firmware binaries if
you do not want the device firmware binaries to be backed up. Checking these options saves
time and disk space.
Figure 181 Backup CC-SG Screen
3. Click OK. The backup file will be saved in the CC-SG file system, and can be restored at a
later time and a success message will appear to confirm CC-SG backup.