Raritan Engineering Command Center CC-SG - Manual (Page 237)

C HAPTER 12: ADVANCED ADMINISTRATION 221
Account Configuration
By default, the status account does not require a password, but you can configure it to have one
here. Other aspects of the admin password can be configured and the Field Support accounts can
be enabled or disabled.
1. To configure accounts, click Operation, Admin, Change Passwords, then Account
Configuration.
Figure 284 Account Configuration
2. View the settings for each account, that is Status, Admin, FS1 and FS2.
Figure 285 Configuring Accounts
3. If you want to require a password for the Status account, select Enabled underneath it.
This screen is split into three main areas:
• The top displays read-only information about the accounts on the system.
• The middle section displays the various parameters related and pertinent to each ID, along
with a set of buttons, to allow the parameters to be updated or new passwords provided for
the accounts.
• The final area restores the password configuration to Factory Defaults (or how the system
was initially shipped).