Raritan Engineering Command Center CC-SG - Manual (Page 91)

C HAPTER 6: C ONFIGURING P ORTS AND P ORT G ROUPS 75
Chapter 6: Configuring Ports and Port Groups
This chapter discusses how to configure and edit ports and port groups. Procedures on how to use
ports (connect, disconnect, bookmark ports, search for ports, create views, use port power
management, use port chat) are described in Raritan’s CommandCenter Secure Gateway User
Guide.
Port Manager
Port Manager commands allow you to configure, connect to, and disconnect from ports of serial
devices, generic devices, IPMI servers, and KVM devices in your CC-SG.
Once configured, CC-SG provides centralized access to the target devices(s) attached to
Dominion and IP-Reach units. CC-SG supports Raritan products, as listed in the table below.
R ARITAN U NITS N UMBER OF P ORTS SSL
Dominion SX4 4 Always On
Dominion SX8 8 Always On
Dominion SX16 16 Always On
Dominion SX32 32 Always On
Dominion SX48 48 Always On
Dominion KSX440 8 Always On
Dominion KSX880 16 Always On
Dominion KX116* 16 Always On
Dominion KX216* 16 Always On
Dominion KX232* 32 Always On
Dominion KX416 16 Always On
Dominion KX432 32 Always On
Dominion KX101 1 Always On
IP-Reach Model Dependent Always On
P2-SC Varies Always On
*Requires DKX firmware support