Raritan Engineering Command Center CC-SG - Manual (Page 174)

158 C OMMAND C ENTER S ECURE G ATEWAY A DMINISTRATOR G UIDE
5. Click OK to restart CC-SG or Cancel to exit the screen without restarting. Once you restart
CC-SG, your Broadcast Message appears.
Figure 187 Info Window
6. Click OK to restart CC-SG.
7. CC-SG will restart, and is ready for use.
Shut Down CC-SG
These are the recommended methods for Administrators to shut down and restart CC-SG.
1. On the Setup menu, click Shutdown CommandCenter. The Shutdown CommandCenter
screen appears.
Figure 188 Shutdown CC-SG Screen
2. Type your password in the Password field.
3. Accept the default message or type a message to display to any users currently online in the
Broadcast message field (for example, you might give users a brief time period to finish
their tasks in CC-SG and tell them when they can expect the system to be functional again).
All users will be disconnected when you shutdown CC-SG.
4. Type how much time (in minutes) should pass before CC-SG shuts down in the Shutdown
after (min) field.
5. Click OK to shut down CC-SG or Cancel to exit the screen without shutting down. Once you
shut down, the CC-SG login window appears.
Log on to CC-SG again to continue working, or click Exit on the login screen to close the
browser. You can also shut CC-SG down from SSH – please see section SSH Access to CC-SG
in Chapter 12: Advanced Administration for additional information.
Restart CC-SG after Shutdown
After shutting down CC-SG, use one of these two methods to restart the unit:
1. Use the Diagnostic Console – please see section Diagnostic Console in Chapter 12:
Advanced Administration for additional information.
2. Recycle the power to your CC-SG unit.