Ricoh JP8000 - Manual (Page 114)

Operation
94
1
I
Press the [OK] key.
Note
❒ Follow steps B – I for the other
command sheets.
❒ You can select a pattern regis-
tered with the user tools for
only one command sheet.
❒ To change the value entered,
press the
{Clear/Stop} key and
enter the new value.
J
After you have finished designat-
ing modes for all the command
sheets, select [Outside Area] with
the [
← ← ← ←] [→ → → →] or {{{{~ ~ ~ ~}}}} {{{{} } } }}}}} keys.
K
Select the mode for the outside
area with the [
← ← ← ←] [→ → → →] or {{{{~ ~ ~ ~}}}} {{{{} } } }}}}}
keys.
L
Press the [OK] key.
Note
❒ When you select Photo mode
for both inside and outside ar-
eas, you cannot select different
dot patterns and contrast.
❒ When you want to confirm your
settings, press the
{Make-Up}
key twice. Then press the [OK]
key repeatedly until the panel
display reaches the setting you
want to confirm.
M
If you have selected Photo mode,
select the dot pattern and the con-
trast with the [
← ← ← ←] [→ → → →] or {{{{~ ~ ~ ~}}}} {{{{} } } }}}}}
keys.
Note
❒ Four dot patterns settings are
available:
• Setting 1: clearest
• Setting 2: clearer than setting 3
• Setting 3: clearer than setting 4
• Setting 4: clearer than the stan-
dard setting
N
Press the [OK] key.