Ricoh JP8000 - Manual (Page 168)

User Tools
148
4
6. Administrator Mode
❖ ❖ ❖ ❖ User Codes
If user codes are turned on, operators must enter their user codes before they can operate
the machine. The machine keeps count of the number of copies made under each user code.
Turn this function on with the “Set User Code(s)” user tool. You can also turn on Key Op-
erator Code mode so that only the key operator (administrator) can use the functions below.
1 Check Counter You can check the number of masters and copies made under
each user code.
Reference
For checking the number of masters and copies, ⇒ P.160 “6-
1 Check Counter”.
2 Reset Counters You can clear each or all user code counters.
Note
❒ Default: Single
Reference
For clearing the number of masters and copies, ⇒ P.161 “6-
2 Reset Counters”.
3 Set User Code Selects User Code mode. For details about User Code mode, ⇒
P.148 “6. Administrator Mode” Use Code(s).
Enter the key Operator Code if you have already set it. ⇒ P.148
“6. Administrator Mode”
Note
❒ Default: Not to use
4 Reg. User Code You can register user codes.
Note
❒ Up to 20 user codes (up to 4 digits) can be registered.
5 Chg. User Code You can change user codes.
Note
❒ The number of copies made under the old code is added to
that made under the new user code.
Reference
For changing the user codes, ⇒ P.162 “6-5 Chg. User Code”.
6 Del. User Code You can delete user codes.
Note
❒ The number of copies made under the deleted code is also
deleted.
Reference
For deleting user codes, ⇒ P.162 “6-6 Del. User Code”.