When prints are not delivered in a neat stack, When printing on small size paper, When the machine cannot detect the paper size – Ricoh JP8000 User Manual
Page 440: 5when prints are not delivered in a neat stack
Troubleshooting
192
5
When Prints Are Not Delivered in a Neat
Stack
When Printing on Small Size
Paper
AAAA
Adjust the angle of the end plate
by turning the screw clockwise or
counterclockwise.
When the Machine Cannot
Detect the Paper Size
If the paper size is not detected cor-
rectly when printing, prints might not
be delivered in a neat stack. To solve
this, do one of the following:
AAAA
Raise the lock lever for the paper
feed side plates to release the
lock.
BBBB
Re-adjust the paper feed side
plates so that there is no space be-
tween the side plates and the pa-
per, and then lock the side plates
in position.
Note
❒ Make sure that the paper size
and direction in the panel dis-
play match the actual paper size
and direction of the paper on
the feed tray.
❒ If the paper on the paper feed
tray has a solid image on its
back side, the machine may not
be able to detect the size correct-
ly. Place a sheet of paper of the
same size without an image on
the back at the bottom of the pa-
per stack.
ZDCH150E
ZDCY111E
ZDCY030E