Ricoh JP8000 - Manual (Page 270)

Operation
22
1
Energy Saver Mode
If you do not operate the machine for a certain period the machine can enter
Idling for pre-printing function to remove ink from inside the ink drum, and
then the machine can enter Energy Saver mode to save energy consumption.
You can press the
{{{{Clear Modes/Energy Saver}}}} key to cancel Energy Saver mode
and return the machine to the ready condition.
Idling for pre-printing function helps to reduce excess ink when printing. It re-
duces recovery time from Energy Saver mode.
Energy Saver mode uses less electricity.
Note
❒ If you press the {{{{Clear Modes/Energy Saver}}}} key for more than three seconds,
the machine will enter Idling for pre-printing function, and then it will enter
Energy Saver mode.
❒ You can change the setting so that the machine does not enter Idling for pre-
printing function. See “Setting Q.start” on p.146 “4. Mode Setting”.
❒ Idling for pre-printing function lasts for a few seconds.
❒ You can change the time the machine waits before Energy Saver mode starts.
See “Energy Saving” on p.143 “1. System”.
❒ The machine will not automatically enter Energy Saver mode in the following
cases:
• If there is no ink
• If originals or paper are jammed
• If the machine is making master or printing
• If the machine is printing the second page of a combined print job
• If the machine is loading original images in memory
• If there is no paper
• If there is no master
• If the paper delivery box is full
• If originals are left on the document feeder
• If there are originals still on the machine
• If the “cover open” message is displayed
• If the settings have been reset to their defaults
• If there are prints in the sorter's paper delivery tray
• If the User Code entry screen is displayed