Ricoh JP8000 - Manual (Page 189)

x Clearing Misfeeds
169
5
x Clearing Misfeeds
R CAUTION:
Note
❒ After clearing misfeeds, make sure
that all the doors, covers, and units
are closed and the
x indicator is
off.
❒ To prevent misfeeds, do not leave
any torn scraps of paper, originals,
or masters in the machine.
❒ When clearing misfeeds, do not
turn off the main switch. If you do,
your print settings will be cleared.
❒ If misfeeds occur repeatedly,
please contact your service repre-
sentative.
”
x x x x + A” Paper Misfeeds in the
Paper Feed Section
A
Remove the misfed paper.
- - - -To prevent paper misfeeds:
Check the following before restarting
the printing run.
• Did you select an appropriate pa-
per type with the [Ppr.Type] key?
• Are the side pads in the correct po-
sitions?
To print on thin paper (47.1g/m 2 ,
12.5 lb), slide the levers behind the
paper feed side plates in the direc-
tion of the arrow (see illustration).
• Be careful not to cut
yourself on any sharp
edges when you
reach inside the ma-
chine to remove mis-
fed sheets of paper or
masters.
ZDCY140E