Ricoh Aficio SP 1000SF - Manual (Page 19)

SP 1000SF
- 16 -
2 - Installation
(3) Paper with waved ends, paper which is creased, paper
with crumples, and any other non-normal paper must
not be used.
Handling the unit
Operator shocks
During printing, shocks must not be applied to the paper
feed cassette, tray, cover, and other parts of the machine.
Moving the unit
When moving the unit on a desk, it must be lifted, and not
dragged.
Handling the Toner Cartridge
(1) Must not be stood on the side, or held upside down.
(2) Must not be shaken strongly.
Feed cassette paper insertion
Your device accepts a number of formats and types of
papers.
1 Remove the paper feed cassette completely.
2 Push the lower panel down until it clicks.
3 Setup the back side feed cassette stop by pushing
the "PUSH" lever (A).
Then adjust the lateral paper guides to the paper
format by pushing lever (B) located on the left
guide. Adjust the length paper guide to the paper
format by pushing lever (C).
4 Take a paper stack, pull the paper off and align it
on a flat surface.
5 Put the paper stack in the feed cassette
(200 sheets for 80 g/m² paper for instance).
6 Put the feed cassette back in its location.
Cartridge installation
1 Stand in front of the machine.
2 Push the left and right sides of the cover and pull it
at the same time towards you.
3 Remove the starter toner cartridge from its bag.
Gently roll the cartridge 5 or 6 times to distribute the
toner evenly inside the cartridge.
Thoroughly rolling the cartridge will assure the
maximum copies per cartridge.
Important
See chapter Specifications for the
various formats and types of paper.
PUSH
B
A
C
8 7¼ 5½