Roland AT90S - Manual (Page 141)

139
Chapter 7 Recording/Playing Back What You Play
Saving Performance Songs
Onto Floppy Disk
The performance data that you recorded will disappear
when the power of the AT-90S/80S/60S is turned off. If you
wish to keep the performance data, you can save it on a
floppy disk.
If the performance data has never been saved to a floppy
disk, a “ ” symbol appears on the Main screen. When
the performance data is saved to a floppy disk, this symbol
will no longer be displayed.
1. Make sure that the disk drive contains a disk that
was formatted by the AT-90S/80S/60S.
2. Touch <Rec/Play> on the Main screen.
The Rec/Play screen appears.
fig.07-04_50
3. Touch <Utility>.
The Utility screen appears.
4. Touch <Save/Delete>.
The Song Save/Song Delete screen appears.
fig.07-28_50
5. Touch < >< > to select the number of the
save destination.
Numbers which have not been used in the saving
operation will be displayed as “- - - - -.”
fig.07-28_50
To cancel the Save operation, touch the <Exit> button to
close the Song Save/Song Delete screen.
6. Touch <Save>.
The Save Format screen appears.
fig.07-29_50
7. Touch the screen to select the format in which the
data will be saved.
You can select either “ORIGINAL” or “SMF” format.
8. Touch <OK> to finalize the save format.
Saving of the performance data will begin.
NOTE
Music files that was saved in Atelier format cannot be played
back correctly on instruments other than the Atelier series.
NOTE
SMF data saved by the Atelier is saved in Format 1 for use
with Atelier sound generators. For this reason, such data
cannot be played back properly by the sound generator of an
instrument that is not a member of the Atelier series.
Display Description
ORIGINAL Save data in Atelier format
SMF Save data in SMF format
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence