Roland AT90S - Manual (Page 157)

155
Chapter 8 Editing Your Musical Performance Data
9. Touch < >< > to set “From” (the measure at
which copying will begin).
10. When you’re done making the settings, touch
<Exit>.
11. Touch the “For” value (the number of measures
to be copied).
12. Touch < >< > to set “For” (the number of
measures to be copied).
If you wish to erase to the last measure (bar), set “for:
ALL.”
13. When you’re done making the settings, touch
<Exit>.
14. Touch the “To” value (the copy-destination
measure number).
15. Touch < >< > to set “To” (the copy-
destination measure number).
If you select “END,” the data will be copied following
the end of the last measure.
16. When you’re done making the settings, touch
<Exit>.
17. Touch the “Time” value (the number of times
that the data will be copied).
18. Touch < >< > to set “Time” (the number of
times that the data will be copied).
19. When you’re done making the settings, touch
<Exit>.
20. Touch <Execute>.
The following display appears.
fig.08-06
To cancel operation, touch <Cancel>.
21. Touch <OK> to copy the measures.
Once the measures have been copied, you are returned
to the Edit Menu screen.
Correct Timing Inaccuracies
(Quantize)
You can correct for timing discrepancies in a recorded
performance by having the music be aligned with a timing
you specify. This is called “Quantizing.”
For example even if you intend to play at quarter-note
timing, the notes may be slightly earlier or later than precise
quarter-note intervals. In this case, if you quantize at quarter-
note (1/4) timing, you can correctly match the rhythms.
1. Touch <Rec/Play> on the Main screen.
The Rec/Play screen appears.
fig.08-02_50
2. In the Rec/Play screen, touch <Utility> to open
the Utility screen.
fig.08-03_50
3. In the Utility screen, touch <Edit>.
The Edit Menu screen appears.
fig.08-08_50
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence