Roland AT90S - Manual (Page 42)

40
Chapter 1 Selecting and Playing Sounds
■ Selecting a Voice Using the [Others] Button
Notice that there is an [Others] button for each of the “Organ,”
“Symphonic,” “Orchestral” sections of the upper and lower voices, and
“Solo” voices, and for the “Organ” and “Orchestral” sections of the Pedal
bass voice. By using the [Others] button, you can select all the other voices,
the ones that can’t be selected directly by pressing voice buttons.
As with the other voice buttons, the [Others] button can be assigned two
voices (one voice for “Pedal Organ” and one for “Pedal Orchestral”). You
can use the [Alternate] button to switch between these two voices.
1.
Press the [Alternate] button for the Part for which you wish
to specify a voice to select ON (lit) or OFF (dark).
The setting of the [Alternate] button: ON (lit) or OFF (dark), determines to
which of the two available locations a newly selected voice will be assigned.
2.
Press the [Others] button for the Part for which you wish to
specify a voice.
The Others Voice screen appears for several seconds.
fig.01-15
3.
Touch a button that shows a sound group.
A sub-window appears, allowing you to select a sound group.
fig.01-16
NOTE
You cannot assign the same
voice to the two available
locations under each
[Others] button. Please
select and assign two
different voices.
Step 1 is unnecessary in the
case of Pedal Bass Part.
NOTE
When you press the
[Others] button, the Others
Voice screen appears in the
display screen, but the
basic screen will reappear if
you wait several seconds
without touching the
screen.
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence