Roland AT90S - Manual (Page 23)

21
Before You Start Playing
Turning On the Lights
(AT-90S/80S)
After turning on the power, turn on the [Illumination] switch
(located underneath the left-hand side of the keyboard).
fig. 00-33
Cautions When Using Illumination
fig.00-31
When the illumination is used for an extended period, the
light bulbs and the metal parts near the light bulb (see
diagram below) will become hot. Be careful not to touch
these areas. In particular, be careful of the following
locations.
1. Panel illumination light bulb (AT-90S, AT-80S)
Do not touch the light bulb or nearby parts. When
closing the lid, be sure to hold the handles.
2. Metal fittings of the cover (AT-90S, AT-80S)
After closing the lid, do not touch this area.
3. Music stand (AT-90S only)
Do not touch the light bulb cover.
4. Light bulb cover for foot area (below keyboard)
(AT-90S only)
The entire cover will become hot. Be careful not to touch
your leg to this area.
The bulbs used for illumination can be replaced. For details
on replacing a bulb, refer to
“Replacing the Illumination
Bulbs” (p. 214).
AT-90S
fig.00-34
AT-80S
fig.00-35
AT-90S
The illumination for the AT-90S’s music
stand, front panel, and pedalboard (below the
keyboard) will light.
AT-80S
The panel illumination of the instrument will
light.
Illumination
On
1 3
4
2
Illumination Switch
1
2
Illumination Switch